Molybdenum Friction ModifiersNova Additives

MO-300

Molybdenum dithiocarbamate

Higher active content than the 40 %-oil grade while staying pourable. The middle option when MO-525 dilutes too much and MO-280 is too hard to handle.

Request a sample→Request TDS & SDS

Typical propertiesLiquid

Molybdenum: 9.1 – 11.2%
Sulphur: 9.4 – 12.1%
Oil: 20%

Typical values, not a specification. The binding specification is the one on the certificate of analysis issued against each batch.

The chemistry

Molybdenum Friction Modifiers

Friction reduction via in-situ MoS₂ tribofilm

Typical treat rate0.1 – 1.0 %

Organomolybdenum compounds decompose under load to deposit molybdenum disulphide in the contact. The measurable result is a lower boundary friction coefficient and a direct fuel-economy credit — which is why these carry the highest value density of anything in this catalogue and why they matter regardless of powertrain.

Used in

Fuel-economy engine oilsDriveline & transmission fluidsGreasesEV thermal fluidsIndustrial gear oils

Where MO-300 is specified

Engine Oils

Passenger-car, heavy-duty and gas engine crankcase formulations, including low-SAPS.

Greases

Lithium, lithium-complex, calcium sulfonate and polyurea thickened greases.

Driveline & Transmission

Automatic and manual transmission fluids, axle oils, EV reduction-gear fluids.

Other grades in OFM (Mo)

View all →

Documentation

A full technical data sheet, safety data sheet in the language of the receiving country, REACH status statement and SVHC declaration are issued with every enquiry for MO-300. Certificates of analysis accompany each consignment and retained samples are held for the full shelf life.

Request the document pack →